Gasboy Fuel Point PLUS Station - Manual (Page 124)

Appendix C
µWNR-B & µWNR-T Installation Instructions
1. GENERAL
This manual describes the mechanical installation of Gasboy's µWNR-B, part of
the Fuel Point PLUS Wireless Vehicle Identification System (see Figure 1).
Figure 1. Fuel Point PLUS System Architecture
1.1. Nozzle Models
This document provides instructions for installing the µWNR-B on the following
nozzle models:
 OPW 11 A/B
 OPW 11AP/BP
 ZVA SL
 OPW DEF
 HUSKY X
 HUSKY A1
 HUSKY 1-8
 HEALY 400/600/700/800/900
 OPW 7H
 ZVA 25
2. REQUIRED TOOLS
The following tools are required to install and service the µNR:
 Flat screwdriver
 Phillips screwdrivers
 3mm and 2mm Allen keys
 Crimping tool
 Wire stripper
 Utility knife
 Loctite 243 medium strength threadlocker glue, or similar
 A pair of cutters