Gasboy Fuel Point PLUS Station - Manual (Page 61)

Fuel Point PLUS Station Equipment Manual 61
Field Description
Group
Address
RS-485 address of the group (between 31 and 39). Despite the fact that Master Wireless Gateway is connected
to Station Controller via Ethernet, this parameter should be set since it is part of Wireless Gateway-SC protocol
messages. If using SiteOmat, this parameter should match the Hex Address field defined in VIS Setup dialog.
See
Setting the Station Controller
Comm.
Interface
Communication interface between the Master Wireless Gateway and the other components in the group. Since
Master Wireless Gateway communicates to other Wireless Gateway units and Wireless Nozzle Readers via a
wireless link, the Wireless option should be selected
Submit Saves the settings of the current tab. To apply the changes, see Saving Setup
6.5.5. WNR Setup
This tab enables you to change advanced settings for the Wireless Nozzle Readers. (see Figure 6-14 ,
Table 6-7 ).
Set the parameters as needed and then click Submit .
Figure 6-14 - WNR Setup