Kanguru Optical Duplicator - Manual (Page 14)

14
3.4 Copy
The Copy function will guide you through making CD/DVD/BD copies.
3.4.1 Making disc to disc copies
The Copy process will copy your master disc onto a single or multiple blank discs simultaneously. Due to
its simultaneous nature, a master disc in good condition and lower recording speeds are recommended for
better quality duplications.
Counter :
No Counter
Kanguru Solutions
1. Copy
1. From the Main Menu, press the UP or DOWN button
to navigate to Copy. Press the ENT button to enter the
Copy menu.
2. You will see the Counter screen. For more information
on the Counter, see section “3.2.2 Setting a Job Counter”
on page 11.
Once you have set the Counter, any trays that do not contain discs in them will automatically be ejected.
You will see the following Preparation screens:
Preparing...
Waiting for Master
Preparing...
Waiting for Blanks
3. Insert your Master disc into the Reader drive and blank discs into the Writer drives.
Note: For a disc-to-disc copy, the master disc can be inserted in any of the disc drives. The Reader is
normally the 1st drive at the top of the tower. You can switch which drive is used as the Reader by changing
the Select Source setting. For more information, see section 3.10 Select Source, p.30.
After you’ve loaded the drives with discs, close the trays and allow 5 - 10 seconds for the system to detect
them. If either of the preparation screens are displayed for more than 2 minutes after you have inserted your
discs, please check the quality of the discs.
Once all the discs have been recognized, you will see the Confirmation screen.
Copy