Kanguru Optical Duplicator - Manual (Page 36)

36
3.13.2 Duplication Mode
The Duplication Mode setting is for Kanguru Duplicator systems with a hard drive installed. If you purchased
a Kanguru Duplicator with a hard drive installed, the Duplication Mode setting allows you to select how
you want to make disc to disc duplications.
There are three duplication modes:
• Load and Copy (hard drive models only) - Allows faster duplication from the hard drive by
simultaneously copying to the blank media in the writer drives while loading an image of the master
disc to the hard drive. Starting from the 2nd round of duplications, all subsequent copies will be
created using the master image loaded onto the hard drive as the copy source. The image will be
loaded onto the RES.VEF partition. If there is already an image on the RES.VEF partition then this
will copy over the existing image.
• On the Fly (default) - Instructs the system to copy directly from the master disc. When using On the
Fly mode, no information is stored on the hard drive.
• Prompt (hard drive models only) – The system will ask you to select the Duplication Mode prior to
performing a copy process.
Note: If your system did not come with a hard drive installed, you will be able to enter the Duplication
Mode menu, but you will only be able to select On the Fly.
Setup
2. Duplication Mode
Duplication Mode
On The Fly
1. From the Setup Menu, press the UP or DOWN button to
navigate to Duplication Mode. Press the ENT button to
enter the Duplication Mode menu.
2. Press the UP or DOWN button to select a Duplication
Mode. Press the ENT button to confirm your selection.
You will exit to the Setup Menu.
Duplication Mode