Kanguru Optical Duplicator - Manual (Page 22)

22
3.7 Test
The Test function will perform a simulation of the copy process. During this simulation process the
Duplicator will test that the master source and target discs will produce error-free duplicates. All blank
single-write recordable discs (e.g. DVD-R, CD-R) will be reusable after testing. Due to the physical
limitation of DVD+R/RW & BD-R/RE recordable format, you cannot perform the Test function on these
formats. If you do so, the LCD screen will display error message 211. For more information on this error
message, please see “Chapter 6. Error Codes” on page 62.
Warning: If you are using CD-RW/DVD-RW discs as your blank media during the Test process, any
content that may have been recorded onto those discs will be permanently erased.
Note: While in the Main Menu, you can press the TEST shortcut button on the LCD panel to directly enter
the Test menu. For more information, please see section “2.4 LCD Panel” on page 8.
Counter :
No Counter
Kanguru Solutions
4. Test
1. From the Main Menu, press the UP or DOWN button to
navigate to Test. Press the ENT button to enter the Test
menu.
2. You will see the Counter screen. For more information
on the Counter, see section “3.2.2 Setting a Job Counter”
on page 11.
Once you have set the Counter, any trays that do not contain discs in them will automatically be ejected.
You will see the following Preparation screens.
Preparing...
Waiting for Master
Preparing...
Waiting for Blanks
3. Insert discs into the drives.
After you’ve loaded the drives with discs, close the trays and allow 5 - 10 seconds for the system to detect
them. If either of the preparation screens are displayed for more than 2 minutes after you have inserted your
discs, please check the quality of the discs.
Once all the discs have been recognized, you will see the confirmation screen.
Test