Kanguru Optical Duplicator - Manual (Page 18)

18
3.5 Compare
The Compare function will perform a bit-by-bit comparison between your master disc (or master image on
the hard drive) and all the copies. The reason for performing this Compare operation is to ensure that all of
your copies contain data identical to the master.
Counter :
No Counter
Kanguru Solutions
2. Compare
1. From the Main Menu, press the UP or DOWN button to
navigate to Compare. Press the ENT button to enter the
Compare menu
2. You will see the Counter screen. For more information
on the Counter, see section “3.2.2 Setting a Job Counter”
on page 11.
Once you have set the Counter, any trays that do not contain discs in them will automatically be ejected.
You will see the following Preparation screens:
Preparing...
Waiting for Master
Preparing...
Waiting for Blanks
3. Insert discs into the drives.
After you’ve loaded the drives with discs, close the trays and allow 5 - 10 seconds for the system to detect
them. If either of the preparation screens are displayed for more than 2 minutes after you have inserted your
discs, please check the quality of the discs.
Once all the discs have been recognized, you will see the confirmation screen.
Preparing :
7 Discs Detected : Go?
Preparing...
Please Wait
Note: The “7” indicates that there are seven discs recognized
by the Writers. The actual quantity may be different
depending on the number of discs you have inserted.
4. When the number of discs detected matches the number
of blank discs you inserted, press the ENT button. You
will see the Processing screen.
Compare