LSC Lighting Redback Wallmount Operators Manual - Manual (Page 19)

Redback Wallmount Dimmer Menu System
Operator Manual V1.3
Page 15
4.4 DIMMER OUTPUT HOME PAGE
The “Dimmer Output” home page shows current level of each channel in a bar graph display
which is colour coded to show the current control source for each channel.
“Dimmer Output” Home Page.
The bargraph shows the output level of every channel. Channels can be controlled from
multiple sources and the colour code of the bargraph indicates the source of the control
signal.
 Green = controlled by DMX
 Blue = controlled by a Memory.
 Red = controlled locally by either the Riggers Control or a “minimum level” channel
setting if DMX is not present.
In the above example, channels 12, 16 and 17 are controlled by a Memory and the large
status button shows you that it is Memory 1 (it is blue).
Channels are controlled on a HTP (highest Takes Precedence) basis. If multiple sources are
controlling a channel (such as DMX and Riggers control) then the highest level will be output
and will hence determine the colour of the bargarph. If a minimum or maximum level has
been set for a channel they are indicated by dots on the channels bargraph.
The top right corner of the screen shows the DMX address information.
 If a 1 to 1 patch is implemented it shows the DMX addresses of the first and last
channels of the dimmer rack.
 If channels are individually patched it shows the word “Patched”.
Pressing [Riggers Control] allows you to control Redback channels directly from the touch
screen as described below.
Pressing [DMX Address] selects the “DMX Address” home page as described below.
4.4.1 Riggers Control
To set the level of a channel(s) (or run a chaser) from the touch screen, select the “Dimmer
Output” home page (above) then press [Riggers Control].
Channel level
bargraphs.
Shows status
and selects
“Status” menu
Selects
“Configuration”
menu
Selects “DMX
Address” home
menu
Selects
“Riggers
Control” menu
DMX Address
(when 1to1
patched)
Help
Dot shows
“Minimum” level
set for a channel.
Dot shows
“Maximum” level
set for a channel.