LSC Lighting Redback Wallmount Operators Manual - Manual (Page 39)

Redback Wallmount Dimmer Wall Plates
Operator Manual V1.3
Page 35
5.3.3 Wallplate Mode Jumper Settings
Mode setting connects the Redback Wall plate buttons to the Redback Wallmount dimmer
memories. The diagrams below depict the Redback Wall plate options with the control
memory number shown inside the circle. From the diagrams below, locate the drawing
which shows the required memory / button configuration and set the Mode jumpers
accordingly.
Note the settings below are the only valid configurations.
A mode must be set for the plate to operate correctly.
Buttons on different wall plates may be connected to the same control line so that the same
memory can be controlled from several locations.