LSC Lighting Redback Wallmount Operators Manual - Manual (Page 34)

Menu System Redback Wallmount Dimmer
Operator Manual V1.3
Page 30
Enter a time in seconds (0 to 9.99) then press [Apply].
See the “Installation” section for details on how to connect a “Panic” button.
4.11 COLOUR THEME MENU
Selecting [Config] [Colour Theme] provides menus for changing the colour of the display.
The choices are:
4.12 SYSTEM MENU
Selecting [Config] [System] provides menus for the following functions:
 Wall plate Setup.
 Reset.
 Code Upgrade.
 Service. (Factory use only).
4.12.1 Wall Plate Setup
The “Wall plate Setup” menu provides functions for configuring the operation of wall plate
switches connected to the Redback dimmer. Wall plates are used to control any of the 6
lighting memories that you have stored in the Redback. Jumpers inside each wall plate allow
you to configure them so that any of the buttons can control any of the 6 memories.
See the “Installation” section for details on how to connect wall plates to the Redback.
See section 5 “Wall Plates” for details on how to configure wall plate operation.
4.12.2 Reset
The Redback provides two different types of reset function.