LSC Lighting Redback Wallmount Operators Manual - Manual (Page 49)

Redback Wallmount Dimmer Quick Reference
Operator Manual V1.3
Page 45
To set a DMX delay time press [Config] [DMX] [Delay]. Enter a time and press [Apply].
To create or edit a “DMX Loss” memory press [Config] [DMX] [D].
Either:
 Press [Snap] to take a copy of either the current [DMX] input signal or the current
state of the Redback’s [Outputs] then press [Apply]
 Select a channel(s) then press [Level]. Enter a level and press [Apply].
When finished press [Exit].
12.4 MEMORY CONTROL
To set a channel(s) to “Memory Only” control press; [Config] [Channels].
Select the required channel(s) then press [Edit].
Repeatedly press [] or [] to select the “Source” parameter.
Press [Memory Only] [Apply] [Exit].
12.4.1 Create or Edit Memories
To Create or edit a memory press;
[Config] [Memories]. Select a memory then press [Edit] either:
 Press [Snap] to take a copy of either the current [DMX] input signal or the current
state of the Redback’s [Outputs] then press [Apply]
 Select a channel(s) then press [Level]. Enter a level and press [Apply].
When finished press [Exit].
12.4.2 Playback Memories
To playback a memory either;
 Use a Wallplate button that has been programmed to control that memory number.
 Press [Config] [Memories]. Select a memory then press [Fade In]/[Fade Out].
12.5 AUTO SWITCH
Channels set to “Auto Switch” will be automatically switched from Memory (Wallplate) control
to DMX control whenever the DMX lighting controller is on (and hence DMX is present).
To set a channel(s) to “Auto Switch”, press; [Config] [Channels].
Select the required channel(s) then press [Edit].
Repeatedly press [] or [] to select the “Source” parameter.
Press [Auto Switch] [Apply] [Exit].
12.6 AUTO POWER
4. Auto Power. When “Auto Power” is activated, channels set to “Auto Power” are switched
ON at full level whenever any DMX signal is present. “Auto Power” is used to provide constant
“non-dimmed” power to fixtures whenever the DMX lighting controller is on(and hence DMX is
present).
To set channel(s) to “Auto Power”, press; [Config] [Channels].
Select the required channel(s) then press [Edit].
Repeatedly press [] or [] to select the “Source” parameter.
Press [Auto Power] [Apply] [Exit].
12.7 RIGGERS CONTROL
From the “Dimmer Output” home page press [Riggers Control].
The output of the Riggers Controls can be turned off or on by pressing
[De activate]/[Activate].
To set the level of a channel(s), use the virtual faders or switches.
To disable the levels set on the faders press [De-Activate].
When finished press [Exit].
12.7.1 Chaser
To activate the chaser, from the “Rigger Control” (above), press [Chaser].
To enable the Chaser press [Activate].
Use the buttons to select a pattern for the chaser.
Set the direction with [l>>> l] (forward), [l<<< l] (reverse) or [l< > l] (bounce from end to end).
Set the speed in BPM (Beats Per Minute).