LSC Lighting Redback Wallmount Operators Manual - Manual (Page 37)

Redback Wallmount Dimmer Wall Plates
Operator Manual V1.3
Page 33
5 Wall Plates
5.1 OVERVIEW
Wall plates are optional remote control switch plates that can be used to control any of the
6 internal memories that are stored in the Redback. Memories are recorded (or edited) from
the Redback’s LCD touch screen. Memories are recalled from wall plates or from the LCD
touch screen.
Wall plates are available with either 1, 2 or 6 buttons. Each button has a LED indicator
which always glows dimly. The LED will flash when its memory is fading up or down and is
bright when its memory is active. The colour of the LED can be selected by jumpers inside
the wallplate.
6 Button Australian Format UK Format Wall Plates
5.2 INSTALLATION
Wall plates are connected to the Redback Wallmount dimmer using CAT5 cable. All
connections are via industry standard RJ45 connectors. Wall plates require all 8 wires in the
CAT5 cable to be connected. Two wires are used for power and 6 wires for the control
signals. The Redback and the wallplates have 2 RJ45 connectors allowing the cable to be
daisy chained from plate to plate.
5.2.1 RJ45 Connections
Pin Number Function
1 Control Line 1
2 Control Line 2
3 Control Line 3
4 + V Power
5 Control Line 5
6 Control Line 6
7 Control Line 7
8 Ground
Redback
Wallmount
Dimmer Wallplate Wallplate Wallplate