LSC Lighting Redback Wallmount Operators Manual - Manual (Page 27)

Redback Wallmount Dimmer Menu System
Operator Manual V1.3
Page 23
Use the keypad to set the level then press [Apply].
4.8.2.2 Taking a Snapshot
To create a memory by taking a snapshot, press [Snap] from the “DMX Loss Memory”
menu above.
Pressing [DMX] will take a snapshot of the current DMX input signal.
Pressing [Outputs] will take a snapshot of the current output of the Redback. These
channel levels could be coming from DMX, Memories, Riggers Control or a combination of
all three.
When you take the snap, the channels levels will be displayed in the box.
To save the snapshot to the memory press [Apply].
The channels levels that were captured in the snapshot can be edited by manually setting
channel levels as described above.
4.8.2.3 Fade Time
When editing the DMX Loss memory (above), you can set a fade time for the memory by
pressing [Fade].
Enter a time in seconds (0 to 99.99) then press [Apply].
Channel levels in
the snapshot