LSC Lighting Redback Wallmount Operators Manual - Manual (Page 23)

Redback Wallmount Dimmer Menu System
Operator Manual V1.3
Page 19
Memory Button
Touch a memory to select it. The currently selected memory is highlighted.
 Press [Fade In]/[Fade Out] to see the selected memory on the output of the
Redback.
 Press [Edit] to edit the selected memory. You can either take a [Snap] (snapshot)
of the current DMX input signal or the current state of the Redback’s Outputs or
select a channel(s) and manually set their levels using the controls on the screen.
4.7.1.1 Manually Setting Channel Levels
The “Memory Setup” menu (above) shows the first 6 channels. Use the [<] or [>] buttons
to see the other groups of 6 channels (if fitted). The navigator at the top right of the screen
shows current group of 6 selected channels highlighted.
Touch a channel to select it. You can select multiple channels. To select a range of channels
select your first channel then press [Thru] then your last channel. Use [All] to select all
channels. Press [None] to de-select all channels.
When you have selected your channel(s) press [Level].
Use the keypad to set the level then press [Apply].
4.7.1.2 Taking a Snapshot
To create a memory by taking a snapshot, press [Snap] from the “Memory Setup” menu
above.
Pressing [DMX] will take a snapshot of the current DMX input signal.
Pressing [Outputs] will take a snapshot of the current output of the Redback. These
channel levels could be coming from DMX, Memories, Riggers Control or a combination of
all three.
Navigator shows
current group of 6
selected channels
highlighted
Selects next group
of 6 channels (if
fitted)