LSC Lighting Redback Wallmount Operators Manual - Manual (Page 6)

Product Description Redback Wallmount Dimmer
Operator Manual V1.3
Page 2
4. Auto Power. Channels configured for “Auto Power” are used to provide power to non-
dimmable fixtures whenever the lighting controller is switched on and hence a DMX signal is
detected on the input to the Redback. When “Auto Power” is enabled, channels configured
for “Auto Power” will be automatically switched ON at full level whenever any valid DMX
signal is detected. These channels will remain on for a programmable “hold time” when DMX
is no longer detected.
LSC recommends that fixtures requiring non-dimmed power should always be connected to
Redback channels fitted with the “Switch” output option. See section 1.4.2 for details.
The following diagram shows a simplified version of the control sources that can be chosen
for every channel.
1.3 MODELS
The Redback Wallmount range of dimmers is designed for permanent installation and is
available in either 6, 12 or 24 channels.
6 channels
Internal terminal output option
shown
12 channels
UK output socket option shown
24 channels
GST18 output socket option shown
1.4 FACTORY FITTED OPTIONS
The Redback Wallmount dimmers can be supplied with the following factory fitted options:
1.4.1 Input RCD Protection
Redback’s can be supplied with an input RCD (Residual Current Device) breaker.
 The 6 channel and 12 channel models are fitted with a single 3 phase 4 pole RCD.
 The 24 channel models are fitted with a three 2 Pole RCD’s, one for each phase.
Auto Power
Presence of a DMX signal
switches channel to FULL ON
Individual
selection for
every Channel.
Presence of a DMX signal
switches channel to DMX Input
MEM/DMX
Switch
Memory Only
Auto Switch
DMX Only
DMX Input
Remote Control
from Wall plates
Redback
Channel
Memories
1 to 6