Visara LINCS Configuration - Manual (Page 153)

135
Chapter 7. SNA Options
707023-003
X.25
APPN Predefined Circuit 0004 LINCS C8.2 Central
Control
Line: HSC2.1
Link Profile: 06 (X25_LINK)
Adjacent CP Name: THISNTWK . ________ (netid.cpname)
Adjacent Node Type: LEN
CP-CP Session Support: Disable
Secondary Station Address: 02
Remote DTE Address: ________________
Connection ID Password: ____________
PF: 1-Menu 4-Add 5-Delete 7-Back 8-Forw 9-Default 10-Done
Adjacent CP Name
This field defines the fully qualified CP name which will be used to identify the Adjacent
Node. It is required for LEN End Nodes, and may be left blank for other nodes, allowing any
CP to communicate over the indicated LAN/SAP or PU address.
If desired, a CP Name may be duplicated on multiple circuits to allow for multiple links to a
given adjacent node.
Adjacent Node LAN/SAP Address
These fields are displayed when the selected Link Profile is configured for LLC. It allows for
the definition of the Adjacent Nodes PU 2.1 LAN/SAP address.
Adjacent Node Type
This toggle field specifies the node type of the adjacent node. Valid options are Learn (Default),
LEN, Network, and End.
If LEARN is specified, this APPN node will dynamically learn the node type of any adjacent
CP which communicates over the indicated LAN/SAP or PU address.
DLCI
The Data Link Connection Identifier (DLCI) is the address of the PVC used to connect this
LINCS node to the Frame Relay network. It should be provided by your Frame Relay service
provider when you arrange for your connection.
Connection ID Password
For X.25 APPN Predefined Circuits:
The Connection ID Password is up to eight hexadecimal digits with embedded spaces allowed.
Before allowing incoming calls, the Host DTE address is checked for a match with a circuit.
If a circuit is found with the DTE address, then the Connection ID Password is checked. If
there is a match, then incoming call is accepted. LINCS then sends a QXID to the station, and
uses the response to determine if the call should be allowed/dropped.