Visara LINCS Configuration - Manual (Page 77)

59
Chapter 3. Line Options
707023-003
This field contains the Ethernet node address of the LINCS node. It is a 12-character
hexadecimal address, and can be any hex value you wish.
Within the most significant byte, the lowest bit specifies a group address and the next bit
specifies a locally administered address. Ethernet addresses configured by LINCS must be
arranged in IEEE format where the most significant bit is on the right of each byte.
802.2 LLC
This toggle field must be enabled to configure any connections or circuits with LLC link
levels (including LANSYS connections, LU to PU mapped circuits, LLC gateway circuits
and LLC host circuits).
Note: This option should not be used to enable 802.2 on IPX. Use the IPX Options panel
(reached from the Line Options panel if IPX has been enabled on any line).
Options are: DISABLE or ENABLE
TCP/IP
This toggle field must be enabled to configure any connections or circuits with TCP/IP link
levels (TELNET connections, gateway circuits, and 3270 host circuits).
Options are: DISABLE or ENABLE
IPX
This toggle field is used to enable IPX protocol support. For example, IPX must be enabled to
support IPX SNA Server or IPX Router through this board.
Options are: DISABLE or ENABLE
IP/Bridge
This toggle field is used to dedicate this adapter to the IP Channel Bridge feature. When
enabled, no other protocol listed on this panel is allowed except the Coax/Ethernet bridge. A
channel interface must also be installed on this panel in order for this selection to be valid.
Options are: DISABLE or ENABLE
LAT (ETH Only)
This toggle field is used to enable LAT protocol support.
Options are: DISABLE or ENABLE
Coax Ethernet Bridge
This toggle field is used to designate this adapter to handle data traffic to and from Network
Computing Terminals attached to coax adapters within the 1174.
Options are: DISABLE or ENABLE