Visara LINCS Configuration - Manual (Page 95)

77
Chapter 3. Line Options
707023-003
IPX SNA Server LUs
LUs is the maximum number of LUs available to IPX SNA Clients, and applies to all lines
with IPX enabled. This number also must not exceed the number of IPX SNA Clients enabled
by the installed FAD(s).
• Min=0
• Max=40481024
• Default=0 LUs
A warning is displayed if a non-zero value is specified and IPX has not been enabled on any
LAN board.
SPX Verify Timeout
The frequency at which LINCS sends a packet to the other side of a connection to inform it
that this side is still alive, in seconds:
• Min=1
• Max=30
• Default=6
SPX Listen Timeout
The number of seconds LINCS will wait without receiving a packet from the other side of the
connection before it starts sending packets to the other side asking for verification that the
connection still exists.
• Min=1
• Max=360
• Default=12
SPX Abort Timeout
The number of seconds LINCS will wait without receiving any response from the other side
of the connection before it terminates the session.
• Min=60
• Max=600
• Default=60
SPX Retry Count
Number of times LINCS resends an SPX data packet.
• Min=1
• Max=255
• Default=10