Visara LINCS Configuration - Manual (Page 76)

58
LINCS Configuration
707023-003
Line Options/FET
The Line Options/FET panel is used to define which protocols are to be supported by the 10/
100 Mbps Ethernet card supported by LINCS, and what hardware or MAC address is to be
used. An example of the panel is shown below.
Line Options/FET1 LINCS C8.2 Central Control
LAN Address: 0000 0000 0000
Media Type: Auto Negotiate
Duplex Mode: Auto
802.2 LLC: Disable
TCP/IP: Enable
IPX: Disable
IP/Bridge: Disable
Coax Ethernet Bridge: Disable
PF: 1-Menu 7-Back 8-Forw 9-Default 10-Done
Line Options/ETH
The Line Options/ETH panel is used to define which protocols are to be supported by the
older 10 Mbps Ethernet card supported by LINCS, and what hardware or MAC address is to
be used. An example of the panel is shown below.
Line Options/ETH1 LINCS C8.2 Central Control
LAN Address: 0200 1174 0000
802.2 LLC: Enable
TCP/IP: Enable
IPX: Disable
IP/Bridge: Disable
LAT: Enable
Coax Ethernet Bridge: Disable
PF: 1-Menu 7-Back 8-Forw 9-Default 10-Done
Because of the similarities of options supported by the FET and ETH cards, the configuration
options will be described together, with differences between the two cards being noted.
Pressing PF8 may cause additional line panels to be displayed based on the protocol selections.
They are:
• LLC Options
• TCP/IP Options
• IPX Options
• LAT Options (ETH only)
• LAN Address