Visara LINCS Configuration - Manual (Page 30)

12
LINCS Configuration
707023-003
Gateway Menu
The Gateway Sub-Menu is used when you only need to add or modify Gateway configuration
data. You can enter the Gateway configuration process at any point you wish, which is good for
updates. Or you can run through the complete process, by starting at Line Options, and PF8-
Forwarding through all the panels necessary to add Gateway to your existing configuration.
Gateway Menu LINCS C8.2 Central Control
Item Description
1 Line Options
2 Link Profiles
3 Gateway Circuits
Select Item: Depress Enter
PF: 1-Menu 3-Panel_List 10-Done
IPX Router Menu
The IPX Router configuration submenu allows you to configure LINCS to be an IPX router.
Either Ethernet and/or Token Ring lines are supported for IPX routing. Any combination of
Ethernet and Token Ring lines carrying IPX traffic can be routed. The example panels used in
this document shows you both a Token Ring and an Ethernet line, which LINCS will route
IPX traffic between.
IPX Router LINCS C8.2 Central Control
Item Description
1 Line Options
2 IPX Options
Select Item: Depress Enter
PF: 1-Menu 3-Panel_List 10-Done
LAT Host Menu
The LAT Host menu allows you to define ASCII hosts running DECnet/LAT on an Ethernet
LAN connected to LINCS. You can enter the LAT Host configuration process at any point
you wish, which is good for updates. Or you can run through the complete process, by starting
at Line Options, and PF8-Forwarding through all the panels necessary to add the LAT Host to
your existing configuration.
LAT Host Menu LINCS C8.2 Central Control
Item Description
1 Line Options
2 ASCII Host Options
3 ASCII Session Profiles
4 LAT Host Classes
Select Item: Depress Enter
PF: 1-Menu 3-Panel_List 10-Done