Dlci on frame relay pvcs panel, Line, Committed information rate – Visara LINCS Configuration User Manual
Page 65: Pf keys on frame relay pvcs panel
47
Chapter 3. Line Options
707023-003
The PVC definition panels are used when:
• You need to configure the CIR for any PVC that cannot use the default CIR (which was
configured on the line panel). DLCI addresses specified elsewhere in configuration (such
as on the host circuit, gateway circuit, or APPN circuit panels) do not have to be defined
on a PVC definition panel, if these PVCs can use the default CIR.
• A PVC has not been specified on an LLC circuit panel, and that PVC will be used on a
line that has LMI disabled. For example, if dynamic Frame Relay circuits have been
specified on an APPN Dynamic Circuit panel for a line with LMI disabled, each DLCI
which may be used for dynamic APPN circuits on that line must be defined on a PVC
definition panel.
No PVC definitions are required if all PVCs may use the default CIR and LMI is enabled.
DLCI on Frame Relay PVCs panel
DLCI is a decimal data entry field that specifies the DLCI address of this PVC.
Valid entries range from 16 to 991, with no default.
A blank or 0 (zero) DLCI may be used to indicate a blank PVC entry.
Line
Line ID toggles through valid Frame Relay lines to specify the line associated with this PVC.
The default is the first Frame Relay line.
The combination of line ID and DLCI must be unique throughout all of the PVC definition
panels:
• DLCIs specified elsewhere in configuration which are not listed on a PVC definition
panel will use the default CIR configured on the line panel.
• DLCIs specified on a PVC definition panel but not referenced elsewhere in configuration
may be used for dynamic connections such as APPN dynamic circuits.
Committed Information Rate
This is the CIR for this DLCI on the specified line.
PF Keys on Frame Relay PVCs panel
The PF4 key is used to add another page of PVC definitions when additional entries are required.
The PF5 key is used to delete a page of existing PVC definitions.
Up to 32 entries may be specified per panel. Up to 8 panels may be displayed for a total
maximum of 256 entries.