H3C Technologies H3C SR6600 - Manual (Page 11)

1
Preparing for installation
Safety recommendations
Safety symbols
When reading this document, note the following symbols:
WARNING means an alert that calls attention to important information that if not understood or
followed can result in personal injury.
CAUTION means an alert that calls attention to important information that if not understood or
followed can result in data loss, data corruption, or damage to hardware or software.
General safety recommendations
• Keep the chassis and installation tools away from walk areas.
• Make sure the ground is dry and flat and anti-slip measures are in place.
• Unplug all the external cables (including power cords) before moving the chassis.
Electricity safety
• Locate the emergency power-off switch in the room before installation. Shut the power off at once in
case accident occurs.
• Make sure the router has been correctly grounded.
• Do not open or close the chassis cover when the router is powered on.
• Use an uninterrupted power supply (UPS).
• If there are two power inputs, disconnect the two power inputs to power off the router.
• Do not work alone when the router has power.
• Always check that the power has been disconnected.
Laser safety
WARNING!
Do not stare into any fiber port when you connect an optical fiber. The laser light emitted from the optical
fiber might hurt your eyes.
The H3C SR6604 and SR6608 routers are a line of Class 1 laser devices.