Replacing a fan tray, Figure 79, Holding the handle of the transceiv – H3C Technologies H3C SR6600 User Manual
Page 85
75
4.
Insert the plastic plug to the removed transceiver module, and put the transceiver module into its
original shipping materials.
5.
If you do not install a new transceiver module in the interface, install a dust-proof plug in the
interface. To install a transceiver module, see "
."
Figure 79 Removing a transceiver module
NOTE:
When replacing a transceiver module, make sure the two transceiver modules connected by the same
optical fiber have the same wavelength.
Replacing a fan tray
CAUTION:
•
The router supports automatic fan speed adjustment and hot-swapping of the fan tray.
•
Keep your hands away from the spinning fan blades when removing the fan tray.
To replace a fan tray:
1.
Use a Phillips screwdriver to loosen the captive screws of the fan tray to be removed until all spring
pressure is released.
2.
Gently pull the fan tray out of the slot along the slide rails.