H3C Technologies H3C SR6600 - Manual (Page 130)

120
Technical specifications
Table 53 FIP-210 specifications
Item Specification
Flash 4 MB
Memory type and size
• Default—Two 1-GB DDR2 SDRAMs
• Maximum—Two 2-GB DDR2 SDRAMs
NVRAM 128 KB
Combo interfaces
2
2 copper ports (automatic
MDI/MDIX)
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
2 fiber ports 1000 Mbps, full-duplex
HIM 2 HIMs supported
MIM 2 MIMs supported
Dimensions (H × W × D) 45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in)
Hardware encryption Supported
Power consumption 125 W
Hot swapping Supported
NOTE:
•
For a combo interface, the default operating port is the copper port.
• For a combo interface, you can use either the copper port or the fiber port. To switch between the copper
and fiber ports, use the combo enable { copper | fiber } command in interface view. For more
information about the combo enable { copper | fiber } command, see H3C SR6600 Routers Interface
Command Reference.
• Use transceiver modules for the fiber ports provided by H3C only. The router might be incompatible with
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.
FIP-210 combo interface specifications
Specification of combo interfaces on the FIP-210 and the FIP-110 are the same. For more information,
see Table 48 and Table 49 .
Transceiver modules for the FIP-210 and for the FIP-110 fiber ports are the same. For more information,
see
Table 50 .
Maximum interface modules provided by FIP-210 in full configuration
Table 54 Maximum interface modules provided by FIP-210 in full configuration
Interface
module
One RPE-X1 Two RPE-X1s One RSE-X1 Two RSE-X1s
SR6604 SR6608 SR6604 SR6608 SR6604 SR6608 SR6604 SR6608
FIP-210 2 4 2 4 2 4 1 3