H3C Technologies H3C SR6600 - Manual (Page 127)

117
The OPEN BOOK mark indicates that the operator must read the following chapters before working with
the FIP:
Table 46 References for FIP operations
Operation Reference
Install and remove the FIP See " Installing a FIP module " and " Replacing a FIP module ."
Install and remove MIMs See " Installing a MIM " and " Replacing a MIM ."
Connect network cables See " Connecting an Ethernet cable ."
Connect optical fibers See " Connecting a fiber cable ."
Technical specifications
Table 47 FIP-110 specifications
Item Specification
Flash 4 MB
Memory type and size
• Default—Two 1-GB DDR2 SDRAMs
• Maximum—Two 2-GB DDR2 SDRAMs
NVRAM 128 KB
Combo interfaces
2
2 copper ports (automatic
MDI/MDIX)
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
2 fiber ports 1000 Mbps, full-duplex
HIM Not supported
MIM 4 MIMs supported at the same time
Dimensions (H × W × D) 45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in)
Hardware encryption Supported
Power consumption 75 W
Hot-swapping Supported
NOTE:
•
For a combo interface, the default operating port is the copper port.
• For a combo interface, you can use either the copper port or the fiber port. To switch between the copper
and fiber ports, use the combo enable { copper | fiber } command in interface view. For more
information about the combo enable { copper | fiber } command, see
H3C SR6600/SR6600-X
Routers Interface Command Reference.
• Use transceiver modules for the fiber ports provided by H3C only. The router might be incompatible with
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.