H3C Technologies H3C SR6600 - Manual (Page 129)

119
Model
Central
wavelength Connector Optical fiber
Transmission
rate
Max. transmission
distance
SFP-GE-LH70-SM1
550
1550 nm LC
9/125 μm
single-mode
optical fiber
1250 Mbps
70 km
(43.50 miles)
Maximum interface modules provided by FIP-110 in full configuration
Table 51 Maximum interface modules provided by FIP-110 in full configuration
Interface
module
One RPE-X1 Two RPE-X1s One RSE-X1 Two RSE-X1s
SR6604 SR6608 SR6604 SR6608 SR6604 SR6608 SR6604 SR6608
FIP-110 2 4 2 4 2 4 1 3
MIM 8 16 8 16 8 16 4 12
HIM
Not
supporte
d
Not
supporte
d
Not
supporte
d
Not
supported
Not
supporte
d
Not
supporte
d
Not
supporte
d
Not
supporte
d
FIP-210
You can plug up to two HIMs into the FIP-210 to provide high-speed service processing or plug up to two
MIMs into the FIP to provide high-density narrowband aggregation. The FIP-210 also supports the mix of
a HIM and a MIM.
Figure 113 FIP-210 front panel
(1) Combo interface 1 (2) Combo interface 0 (3) Slot 1
(4) Slot 2 (5) OPEN BOOK mark
The OPEN BOOK mark indicates that the operator must read the following chapters before working with
the FIP:
Table 52 References for FIP operations
Operation Reference
Install and remove the FIP See " Installing a FIP module " and " Replacing a FIP module ."
Install and remove MIMs See " Installing a MIM " and " Replacing a MIM ."
Connect network cables See " Connecting an Ethernet cable ."
Connect optical fibers See " Connecting a fiber cable ."