H3C Technologies H3C SR6600 - Manual (Page 51)

41
Figure 45 8E1 splitter cable
NOTE:
The coaxial connector and 75-ohm E1 adapter cable are optional accessories, and must be purchased
separately if needed.
T1 cable
You can use an 8T1 interface cable to connect to MIM-8T1/MIM-8T1-F modules.
Figure 46 8T1 splitter cable
Connecting an E1/T1 cable
Connecting an E1 cable (D15/D68 <----> BNC)
CAUTION:
When connecting the interface cable, pay attention to the mark on the interface to avoid wrong insertion,
which might damage the interface module or even the router.
• If you do not need to extend the cable, you can directly connect the BNC connectors of the E1
75-ohm cable to the remote network device as follows.