Installing a mim – H3C Technologies H3C SR6600 User Manual
Page 30
20
Figure 17 Installing a HIM
4.
Use a flat-blade screwdriver to fasten the captive screws on the HIM.
5.
Power on the router and check the status LED on the front panel. On means the HIM is installed
correctly and running correctly. Off means the HIM has failed the POST.
Installing a MIM
MIMs are hot swappable and you must perform the remove slot number command to stop the module
before you remove it.
To install a MIM:
1.
Locate the slot to install the MIM on the FIP module. The MIM should be installed in the lower slot
on the FIP module.
2.
Remove the captive screws on the filler panel with a Phillips screwdriver, and then use a flat-blade
screwdriver to prize the filler pane to remove it from the router.
3.
Use even pressure to push the MIM slowly along the slide rails into the slot, and then pull the levers
inward.