HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 152)

5–53 TNC 425/TNC 415 B/TNC 407
5.6 Contours – FK Free Contour Programming
5 Programming Tool Movements
Data on the circle center
Known data Dialog Soft key
X coordinate of the circle center CIRCLE CENTER X COORDINATE ?
Y coordinate of the circle center CIRCLE CENTER Y COORDINATE ?
Polar coordinate radius of the circle center CIRCLE CENTER POLAR RADIUS ?
Polar coordinate angle of the circle center CIRCLE CENTER POLAR ANGLE ?
Data that refer to another contour element or another contour position
Circle end points and circle centers can be entered incrementally relative
to another contour element. For the meanings of the soft keys, see “Free
programming of straight lines” .
Relative data for coordinates of an arc
Relative data for circle center coordinates