HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 339)

11-6
11 MOD Functions
TNC 425/TNC 415 B/TNC 407
11.4 Setting the External Data Interfaces
PRINT and PRINT-TEST
The PRINT and PRINT-TEST functions set the destination for the trans-
ferred data.
Applications:
• Transferring values with the Q parameter function FN15
• Transferring digitized surface data
The TNC mode of operation determines whether the PRINT or PRINT-
TEST function is used:
TNC mode of operation Transfer function
PROGRAM RUN, SINGLE BLOCK PRINT
PROGRAM RUN, FULL SEQUENCE PRINT
TEST RUN PRINT-TEST
PRINT and PRINT-TEST can be set as follows:
Function Setting
Transfer data via RS-232 RS-232
Transfer data via RS-422 RS-422
Save data to a file in the TNC FILE
Do not save data (vacant)
Files in the TNC (FILE setting)
Data Mode of operation File name
Digitized data PROGRAM RUN Set as in the RANGE
cycle
Values with FN15 PROGRAM RUN % FN15RUN.A
Values with FN15 TEST RUN %FN15SIM.A
To change a setting, type it into the highlight and confirm by pressing ENT.