HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 91)

TNC 425/TNC 415 B/TNC 407 4-32
4 Programming
/
4.10 Marking Blocks for Optional Block Skip
You can mark program blocks so that the TNC will skip them during
a program or test run whenever the block skip option is active (see
page 3-10). The interactive graphics, however, ignores the marked
blocks whether the block skip option is active or not.
To mark blocks:
Select the block that should not always be run.
Mark the block with the "/" character on the alphabetic keyboard.
• TOOL DEF blocks cannot be skipped.
• To skip a cycle, place the "/" character in the first cycle block
To delete the "/" character:
Select block from which "/" character is to be deleted.
Delete the character.
X