HEIDENHAIN TNC 407 (280 580) User Manual User Manual
Page 264
8-57
8
Cycles
TNC 407/TNC 415 B/TNC 425
OO
ORIENTED SPINDLE STOP (Cycle 13)
Application
The control can address the machine tool spindle as a 6th axis and turn it
to a certain angular position. Oriented spindle stops are required for
• Tool changing systems with a defined tool change position
• Orientation of the transmitter/receiver window of the TS 511 3D touch
probe system from HEIDENHAIN
Activation
The angle of orientation defined in the cycle is positioned by entering
M19. If M19 is executed without a cycle definition, the machine tool
spindle will be oriented to an angle which has been set in the machine
parameters.
Apart from cycle 13, oriented spindle stops can also be programmed in the machine parameters.
Prerequisite
The machine must be set up for this cycle.
Input data
Angle of orientation (according to the reference axis of the machining
plane)
Input range:
0 to 360°.
Input resolution:
0.1°.
Fig. 8.55:
Oriented spindle stop