HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 255)

8-48
8 Cycles
TNC 407/TNC 415 B/TNC 425
8.5 Coordinate Transformation Cycles
e.g. T A B
+
PGM
NAME
+
Editing a datum table
Datum tables are edited in the PROGRAMMING AND EDITING mode of
operation:
Show the datum tables.
Select the desired file.
Enter new file name, e.g. TAB.D.
Edit the datum table.
The soft-key row comprises the following functions for editing:
Function Soft key
• Jump to beginning of the datum table
• Jump to end of the datum table
• Page up/down
• Insert line
• Delete line
• Enter line, jump to beginning of
next line
• Lines can only be inserted at the end of the file.
• When opening a new datum table, be sure to select the correct dimensions (mm/inch).
• Datums from a datum table can be referenced either to the current datum or to the machine datum. The desired
setting is made in MP 7475 (see page 12-12).