HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 314)

9-47 TNC 425/TNC 415 B/TNC 407
9 3D Touch Probe Systems
TIME LIMIT ?
Enter the time limit within which one contour line must be scanned,
for example 0 seconds (no time limit).
0 e.g. ENT
TOUCH
PROBE
GOTO 7
ENT
ENT
e.g. X 0 Y 0
ENT
e.g. Y
e.g. X
ENT
ENT
0 5 e.g.
ENT
.
.
.
9.5 Digitizing with the TS 120 Touch Probe
LIMIT IN NORMAL AXIS DIRECTION?
Enter the distance of travel by which the probe moves away from
the surface during scanning, for example 0.5 mm.
STARTING PROBE AXIS AND DIRECTN ?
Enter the starting direction, for example X–.
AXIS AND DIRECTION OF APPROACH ?
Enter the approach direction, for example Y–.
To program TCH PROBE 7.0:
TCH PROBE: 0 REF. PLANE
Select the scanning cycle 7: CONTOUR LINES.
TCH PROBE: 7 CONTOUR LINES
Confirm your selection.
STARTING POINT ?
Enter the coordinates of the starting position, for example X+0, Y+0.