TA Triumph-Adler CLP 4524 - Manual (Page 53)

Setting your machine
3-15
Date en cours : 10 janvier 2008
C:\Documents and Settings\g097447\Bureau\LU 253068043 HFC colour USB - UTAX EN\Configuration Gb.fm
Op
er
ati
on
Se
tting y
our
mac
hin
e
Getting started
Director
y
M
aintenance
Safety
Contents
Installation
P
RINT FUNCTION SETTINGS
The printer can be connected to the local network as it has its own IP address.
Updating network settings
The print console allows you to:
• Turn TCP/IP, NetWare and EtherTalk on or off.
• Turn DHCP on or off.
• Enter the IP address, the subnet mask address and the default gateway address.
To check or change the network card settings:
 Press the MENU key.
 Repeatedly press the or keys until INTERFACE appears.
One of the interface names below appears, showing that it is the current interface.
 Press ENTER , a blinking "?" appears.
 Repeatedly press the keys or until OPTIONAL appears.
Press ENTER .
 Press the > key.
 This example shows how to switch the TCP/IP protocol on to connect the terminal to the
network. You can switch Netware or EtherTalk on in the same way.
If TCP/IP is OFF. Press ENTER , a blinking "?" appears. Select ON using the or keys.
Press ENTER again.
Automatically configuring IP settings
You can make these settings when the TCP/IP protocol is on. We recommend that you manually
configure your terminal. However, local network settings can be automatically configured if you
have a DHCP or BOOTP server on your local network which can dynamically distribute
addresses to peripherals on the LAN.
To automatically configure network local settings:
MENU - - INTERFACE > - - TCP/IP > DHCP
 Press ENTER , a blinking "?" appears.
 Select ON using the or , then press ENTER .
• PARALLEL (default setting)
• USB
• OPTIONAL (when the network card is installed)