TA Triumph-Adler DC 2016 - Manual (Page 11)

1-3
PRECAUTIONS FOR USE
Cautions when using the copier
WARNING
DO NOT place metallic objects or containers
with water (flower vases, flower pots, cups,
etc.) on or near the copier. This type of
situation presents a danger of fire or
electrical shock should they fall inside..........
DO NOT remove any of the covers from the
copier as there is a danger of electrical shock
from high voltage parts inside the copier......
DO NOT damage, break or attempt to repair
the power cord. DO NOT place heavy objects
on the cord, pull it, bend it unnecessarily or
cause any other type of damage. These types
of situations present a danger of fire or
electrical shock................................................
NEVER attempt to repair or disassemble the
copier or its parts as there is a danger of fire,
electrical shock or damage to the laser. If the
laser beam escapes, there is a danger of it
causing blindness............................................
If the copier becomes excessively hot, smoke
appears from the copier, there is an odd
smell, or any other abnormal situation
occurs, there is a danger of fire or electrical
shock. Turn the power switch OFF ({)
immediately, REMOVE THE POWER PLUG
from the outlet and then contact your service
representative. ................................................
If anything harmful (paper clips, water,
other fluids, etc.) falls into the copier, turn
the power switch OFF ({) immediately.
Next, BE ABSOLUTELY CERTAIN to
remove the power plug from the outlet to
avoid the danger of fire or electrical shock.
Then contact your service representative. ....
DO NOT remove or connect the power plug
with wet hands, as there is a danger of
electrical shock................................................
ALWAYS contact your service representative
for maintenance or repair of internal parts. .
CAUTION
DO NOT pull the power cord when removing
it from the outlet. Pulling on the power cord
may break the wires and start a fire or cause
an electrical shock. (ALWAYS grasp the
power plug when removing the power cord
from the outlet.)..............................................
ALWAYS remove the power plug from the
outlet when moving the copier. If the power
cord is damaged, there is a danger of fire or
electrical shock. ..............................................
If the copier will not be used for a short
period of time (overnight, etc.), turn the
power switch OFF ({).
If it will not be used for an extended period of
time (vacations, etc.), remove the power plug
from the outlet for safety purposes during
the time the copier is not in use. ...................
HOLD the designated parts only when lifting
or moving the copier.......................................
For safety purposes, always REMOVE the
power plug from the outlet when performing
cleaning operations. .......................................
If dust accumulates within the copier, there
is a danger of fire or other trouble. It is
therefore recommended that you consult
with your service representative in regard to
cleaning of internal parts. This is
particularly effective if accomplished prior to
seasons of high humidity. Consult with your
service representative in regard to the cost of
cleaning the internal parts of the copier.......
DO NOT leave the Document Processor open
as there is a danger of personal injury..........
Other precautions
DO NOT place heavy objects on the copier or cause
other damage to the copier.
DO NOT open the front cover, turn off the power
switch, or pull out the power plug during copying.
When lifting or moving the copier, contact your
service representative.
Do not touch electrical parts, such as connectors or
printed circuit boards. They could be damaged by
static electricity.
DO NOT attempt to perform any operations not
explained in this handbook.
CAUTION: Use of controls or adjustments or
performance of procedures other than those specified
herein may result in hazardous radiation exposure.