TA Triumph-Adler DC 2016 - Manual (Page 24)

Section 3 PREPARATIONS
3-2
1
Pull the drawer all the way out towards you.
Note
Do not pull out several drawers at one time.
2
Push down on the drawer base plate and secure it.
3
Grasp the Width Size Adjustment tab and match the paper
size to the Width Guide.
The paper sizes are impressed in the drawer.
4
Grasp the Length Size Adjustment tab and match the
paper size to the Length Guide.
The paper sizes are impressed in the drawer.
5
Set the paper straight from the upper part.
IMPORTANT!
• Be careful not to bend and crease the paper when
inserting it into the drawer. Creases in the paper may
lead to paper misfeeds.
• The maximum paper limit indicator (1) is on the Width
Guide. Make sure that the paper loaded is below the
maximum limit indicator.
• When loading paper into the drawer, set it so that the
side which was facing upwards in its packaging faces
up.
• Always match the Width and Length Guides to the
paper size before loading the paper. Failure to do so
may result in paper skewing or jamming.
• Make sure that the Length and Width Guides are flush
against the paper. If there is space between the Guide
and the paper, adjust the Length or Width Guide to
eliminate it. If the Guides are not firmly set against
the paper, a size that is different from that in the
drawer may be displayed on the Paper Selection
display.
• When the paper has become wrinkled from moisture,
set the paper so that the wrinkled side is towards the
Length Guide.
Note
When loading paper into the drawer, set it so that the
side that is to be copied faces upwards.
(1)