TA Triumph-Adler DC 2016 - Manual (Page 79)

Section 6 COPIER MANAGEMENT
6-23
5
Press the [OK] key.
The display will return to that of Step 2.
Inch
specifications Metric specifications
Custom Size (1 to 2)
Set the Custom Size.
The setting of Custom Size 1 is shown here as an example. To set
Custom Size 2 select F23 in the Default Settings Mode and then
perform the same settings.
1
Display the Default Settings Mode. (Refer to P.6-11
"Default Settings Mode Operations Procedures".)
Inch
specifications Metric specifications
2
Press either the Zoom (+) or Zoom (–) key to display “F22”.
Inch
specifications Metric specifications
3
Press the [OK] key.
Inch
specifications Metric specifications
4
Press either the Zoom (+) key or the Zoom (–) key and select
the size.
InP (Irregular Size) When selecting Irregular Sizes, carry
out the following procedure. In the case of the selection of
other sizes, proceed to Step 9.
Inch specifications
Metric specifications
5
Press the [OK] key.
Inch specifications
Metric specifications
6
Press either the Zoom (+) or Zoom (–) key and input the
Length Size (Y Direction) in inch/mm units.
Inch specifications
Metric specifications
7
Press the [OK] key.
Inch specifications
Metric specifications