TA Triumph-Adler DC 2025 - Manual (Page 100)

4-37
Section 4 Other Features of this Fax
(Inch)
(Metric)
4. Use the one-touch key described in step 2 to enter the destination
fax number.
5. Press the Start key. The transmission operation will begin.
* If the Encryption Key ID designated for the one-touch key is no
longer registered in this fax, an error will occur and the
transmission will not be completed.
(6) Required Operation (Receiving party)
Perform the following procedure in order to receive and print out
documents under Encrypted Communication.
* F-Code Based Communication is not available for use with
Encrypted Communications.
* If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
1. Register the Encryption Key agreed to in advance with the
transmitting party. (Refer to “(1) Registering Encryption Keys” on
page 4-33.)
* If the Encryption Key has already been registered, go directly to
step 2.
2. Register the Encryption Box that will be used to receive the
encrypted documents. (Refer to “(3) Registering Encryption Boxes”
on page 4-35.)
* If an Encryption Box has already been registered in this way, go
directly to step 3.
3. The transmitting party will send you the encrypted documents.
Once they are received, they are normally decrypted to their
original form and then stored in a specified Encryption Box.
* If the Encryption Box has been registered for manual print out of
the documents, go to the next step.
* If the Encryption Box has been registered for automatic print out
of the documents, received documents will be automatically
printed out upon reception into that box.
4. Refer to “(7) Printing Out Documents from an Encryption Box” on
page 4-38, and print out the received documents from the
corresponding Encryption Box.