TA Triumph-Adler DC 2025 - Manual (Page 38)

1-30
Section 1 Fax Operation (Basic Use)
1
(Inch)
(Metric)
2
3
4
5
6
7
8
Dialing with Abbreviated Numbers
Speed-dial keys are available to be registered as either a one-touch key, a group dial key, a program key or a chain dial key. Each of
these keys is given a 3-digit number between 001 and 600 and this number is referred to as that key's “abbreviated number”. It is then
possible to dial a destination number by simply entering the corresponding abbreviated number.
* Prior to operation, check the message display to make sure that the touch panel is in the initial mode for fax operation.
(Refer to “(2) Initial Mode” on page 1-7.)
* If you want to cancel the procedure part way through, press the Reset key. The touch panel will return to the initial mode settings.
Set the documents you want to transmit.
If you want to change the transmission conditions, such as
the resolution and contrast, touch the “TX setting” key.
If you do NOT want to change the current conditions, go
directly to step 5.
Touch the key that corresponds to the desired item and
change the information as desired.
(To change each transmission condition, refer to pages 1-16
and 1-17.)
Once you are finished changing transmission conditions,
touch the “Abbrev.” key and then go directly to step 6.
Touch the “Abbrev.” key.
Use the keypad to enter the abbreviated number (001 - 600)
that corresponds to the speed-dial key under which the
desired fax number is registered.
* Once a 3-digit number is entered, that number may be
changed using the “+” and “-” keys.
Touch the “Close” key.
The touch panel will return to the basic fax screen and the
corresponding speed-dial key will be highlighted.
Press the Start key.
The transmission operation will begin automatically.