TA Triumph-Adler DC 2025 - Manual (Page 59)

3-3
Section 3 Troubleshooting
_
_
9-7
_
_
4-33
4-39
“Call for Service”
Maintenance by qualified service personnel is required. Contact your service
representative, an authorized service center or the place of purchase. If “C” and a 4-digit
number are displayed as well, inform the service personnel of the displayed number.
“Time for maintenance” [“Time for
scheduled maintenance”] Maintenance by qualified service personnel is required. Contact your service
representative, an authorized service center or the place of purchase.
“Communication Error”
An error has occurred during a fax transmission or fax reception. Check the error code –
that indicates the origin of the error – on the corresponding Transmission Report (or
Reception Report) that is printed out in order to confirm the cause of the error.
“No DC Loop”
“No Dial Tone”
The modular cord may not be connected properly to either the telephone or the line jack
(L) on the fax. Either that, or there is a problem with the telephone line. In this case,
contact your telephone company.
“No Response”
Dialing was accomplished, but connection to the other party was not possible. Check
with the other party.
“No encryption code is registered.”
The destination was dialed using a one-touch key that was designated for Encrypted
Transmission, but the Encrypted Transmission was not possible because the
corresponding Encryption Key is no longer registered in your fax.
Message Procedure Page