TA Triumph-Adler DC 2025 - Manual (Page 26)

1-18
Section 1 Fax Operation (Basic Use)
8
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
Initiating the fax transmission
Press the Start key. The transmission operation will begin
automatically.
* You can select or change the resolution or contrast during
scanning or dialing.
> Checking the status of the transmission...
Touch the “Status” [“Act status”] key in the bottom right of the
touch panel. The document number and information related to
the other party will be displayed.
> Stopping the transmission in progress
It is possible to cancel the ongoing operation by touching the
“Stop”key in the confirmation screen that was accessed
above.
* Touch the “Close” key to return to the previous screen.
<If the Documents Were Set on the Platen...>
Whenever you set the documents that you want to transmit
on the platen, close the Document Processor in order to
allow the machine to detect the size of those documents. If
you are transmitting information from books or other types of
documents that will not allow you to close the Document
Processor, it is necessary to indicate the document size
manually. (Refer to page 1-17.)
* In addition, any time you set documents on the platen for
transmission, a menu like that shown below will appear in
the message display once you press the Start key and the
documents have been scanned. In this case, perform the
following procedure.
> If you have more documents to send...
1 Set the next page to be scanned on the platen.
* The next document(s) may also be set in the Document
Processor.
2 Touch the “Yes” key.
3 Press the Start key.
* If you set the document(s) in the Document Processor,
scanning and then transmission of the documents will
begin automatically.
* Repeat steps 1 through 3 for all remaining documents.
> Once there are no further pages to be scanned...
1 Touch the “No” key. Transmission of the documents will
begin automatically.