TA Triumph-Adler DCC 6526L - Manual (Page 90)

Preparation before Use
2-45
2
Loading Originals in the Document Processor
The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals
are scanned.
Part Names of the Document Processor
(1) Document processor cover
(2) Original width guides
(3) Original table
(4) Original eject table
(5) Original stopper
(6) Document processor open/close handle
Originals Supported by the Document Processor
The document processor supports the following types of originals.
Originals Not Supported by the Document Processor
Do not use the document processor for the following types of originals.
• Soft originals such as vinyl sheets
• Transparencies such as OHP film
• Carbon paper
• Originals with very slippery surfaces
• Originals with adhesive tape or glue
• Wet originals
• Originals with correction fluid which is not dried
• Irregularly shaped (non-rectangular) originals
• Originals with cut-out sections
• Crumpled paper
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam).
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases
before loading. Failure to do so may cause the originals to jam).
(1)
(2)
(3)
(6)
(4)
(5)
Weight 50 to 120 g/m
2
(duplex: 50 to 110 g/m
2
)
Size Maximum A4 to Minimum A5
Maximum Legal to Minimum Statement
Capacity Plain paper, Colored paper, Recycled paper,
High quality paper: 50 sheets
Thick paper (110 g/m
2
): 36 sheets
Thick paper (120 g/m
2
): 33 sheets
Art paper: 1 sheet