Avago Technologies MegaRAID Fast Path Software - Manual (Page 251)

LSI Corporation Confidential | July 2011 Page 251
MegaRAID SAS Software User Guide Chapter 5: MegaRAID Command Tool | Virtual Drive-Related Options
5.14.8 Perform a Virtual Drive
Reconstruction
Use the command in the following table to perform a reconstruction of the virtual
drives on the selected controllers.
Table 89: Virtual Drive Reconstruction
Convention MegaCli –LDRecon {–Start –Rx [Add | Rmv
PhysDrv[E0:S0,E1:S1,...] ] } |–ShowProg|-ProgDsply
–Lx –aN
Description Controls and manages virtual drive reconstruction. The following are the
virtual drive reconstruction settings you can select on a single controller:
-Start : Starts a reconstruction of the selected virtual drive to a new RAID
level.
-Rx: Changes the RAID level of the virtual drive when you start
reconstruction.
You might need to add or remove a drive to make this possible.
-Start –Add PhysDrv[E0:S0,E1:S1....] : Adds listed drives to
the virtual drive and starts reconstruction on the selected virtual drive.
-Start –Rmv PhysDrv[E0:S0,E1:S1....] : Removes one drive
from the existing virtual drives and starts a reconstruction.
-ShowProg : Displays a snapshot of the ongoing reconstruction process.
-ProgDsply : Allows you to view the ongoing reconstruction. The routine
continues to display progress until at least one reconstruction is completed
or a key is pressed.