Avago Technologies MegaRAID Fast Path Software - Manual (Page 295)

LSI Corporation Confidential | July 2011 Page 295
MegaRAID SAS Software User Guide Chapter 6: MegaRAID Storage Manager Overview and Installation | Installing and Configuring an SNMP Agent
NOTE: Tog-pegasus binaries, such as cimmof, cimprovider, and wbemexec, should be
in the PATH variable of /etc/profile, and hence, are defined in all environments of
the system.
To run the CIM SAS Storage Provider on Pegasus version 2.5.x, perform the following
steps:
1. After you install the LSI SAS Pegasus provider, verify that the
libLsiSASProvider.so file and the libLsiSASProvider.so.1 file are in
/usr/lib/Pegasus/providers directory.
If these files are not present, copy the libLsiSASProvider.so.1 file from
/opt/tog-pegasus/providers/lib
to /usr/lib/Pegasus/providers, and
create a symbolic link libLsiSASProvider.so to
/usr/lib/Pegasus/providers/libLsiSASProvider.so.1
at
/usr/bin/Pegasus/providers .
2. Restart the Pegasus CIM Server and LSIServer by performing the following steps:
— To start the tog-pegasus server, run the following command:
# /etc/init.d/tog-pegasus restart
— To start LSISAS Sever, run the following command:
# /etc/init.d/LsiSASd restart
6.6.2 Installing a CIM SAS Storage
Provider on Windows
The following procedure describes how to install and uninstall the LSI CIM SAS Storage
Provider on a system running on a Windows operating system.
Perform the following steps to install a CIM SAS Storage Provider on a Windows system:
1. Go to DISK1.
2. Run setup.exe.
The installer installs all of the necessary files and the MOF, and registers the COM
DLL. The CIM SAS Provider is now ready to use.
Perform the following steps to uninstall a CIM SAS Storage Provider on a Windows
operating system.
1. Select Control Panel > Add/Remove Program.
2. Remove the LSI WMI SAS Provider Package.
This step removes all of the necessary files, uninstalls the MOF, and unregisters the
COM dll. The SAS Provider is no longer on the system.
6.7 Installing and
Configuring an SNMP Agent
A Simple Network Management Protocol (SNMP)-based management application can
monitor and manage devices through SNMP extension agents. The MegaRAID SNMP
subagent reports the information about the RAID controller, virtual drives, physical
devices, enclosures, and other items per SNMP request. The SNMP application monitors
these devices for issues that might require administrative attention.
This section describes the installation and configuration of the LSI MegaRAID SNMP
agent on Linux, Solaris, and Windows operating systems.