Avago Technologies MegaRAID Fast Path Software - Manual (Page 357)

LSI Corporation Confidential | July 2011 Page 357
MegaRAID SAS Software User Guide Chapter 8: Configuration | Changing Power Settings
Figure 224: Manage Power Save Settings Window
3. Select the Unconfigured Drives check box to let the controller enable the
unconfigured drives to enter the Power-Save mode.
4. Select the Hot spare Drives check box to let the controller enable the Hot spare
drives to enter the Power-Save mode.
5. Select the Configured Drives check box to let the controller enable the Configured
drives to enter the Power-Save mode.
6. Select the drive standby time (Alt+D) using the drop-down list from the Drive
standby time field.
NOTE: The Drive Standby time drop-down list is enabled only if any of the check
boxes above it are checked. The drive standby time can be 30 minutes, 1 hour, 1.30
hours, or 2 hours through 24 hours.
7. Select the Power-Save mode using the Select Power- Save mode drop down list.
The mode can be Auto, Max or Max without cache.
NOTE: The Select Power-Save mode drop-down list is enabled only if the Configured
drives check box is selected. The Max without cache mode option depends on the
firmware settings.
8. Click OK.