ProSoft Technology MVI46-DFNT - Manual (Page 159)

MVI46-DFNT ♦ SLC Platform Reference
EtherNet/IP Client/Server Communication Module User Manual
ProSoft Technology, Inc. Page 159 of 177
October 12, 2010
Select Y (or Yes) for the Enabled parameter and then configure each
communication parameter.
Step 2- Configure the Serial/IP Converter Software
Conversion software is required in order to convert serial data to TCP/IP format.
The software will select a serial port that is not being used and direct to it to an IP
address and port number (MVI46-DFNT Pass-Through Server). It is essential to
select the MVI46-DFNT IP address and the port number configured on the
previous step.
The serial communication parameters should also match the parameters
configured in the previous step.
Note: You must obtain, license and install a suitable Serial/IP Converter to perform this function.
This tool is not provided or supported by ProSoft Technology.
Step 3- Configure a RS-232 driver in RS-LINX
Open the RS-LINX software and create a new RS-232 driver: