ProSoft Technology MVI46-DFNT - Manual (Page 78)

Reference MVI46-DFNT ♦ SLC Platform
User Manual EtherNet/IP Client/Server Communication Module
Page 78 of 177 ProSoft Technology, Inc.
October 12, 2010
Before attempting to use the module on a network, verify that the DFNT module
is correctly configured and connected to the network. A network program such as
PING can be utilized to make certain the module can be seen on the network.
Use ProSoft Configuration Builder to verify correct operation, and to transfer
configuration files to and from the module.
The following table shows the supported commands when the module acts as a
slave (server):
Basic Command Set Functions
Command Function Definition Supported in Slave
0x00 N/A Protected Write X
0x01 N/A Unprotected Read X
0x02 N/A Protected Bit Write X
0x05 N/A Unprotected Bit Write X
0x08 N/A Unprotected Write X
PLC-5 Command Set Functions
Command Function Definition Supported in Slave
0x0F 0x00 Word Range Write (Binary Address) X
0x0F 0x01 Word Range Read (Binary Address) X
0x0F Typed Range Read (Binary Address) X
0x0F Typed Range Write (Binary Address) X
0x0F 0x26 Read-Modify-Write (Binary Address)
0x0F 0x00 Word Range Write (ASCII Address) X
0x0F 0x01 Word Range Read (ASCII Address) X
0x0F 0x26 Read-Modify-Write (ASCII Address)
SLC-500 Command Set Functions
Command Function Definition Supported in Slave
0x0F 0xA1 Protected Typed Logical Read With Two Address
Fields
X
0x0F 0XA2 Protected Typed Logical Read With Three Address
Fields
X
0x0F 0XA9 Protected Typed Logical Write With Two Address
Fields
X
0x0F 0XAA Protected Typed Logical Write With Three Address
Fields
X
0x0F 0XAB Protected Typed Logical Write With Mask (Three
Address Fields)