Document Outline

• Modular DeviceNet Starter Auxiliary™ Series C
• Important User Information
• European Union Directive Compliance
  • EMC Directive
  • Low Voltage Directive
• Preface
  • Manual Objectives
  • Intended Audience
  • Vocabulary
  • Reference Manuals
• Table of Contents
• Chapter 1 - Product Overview
  • Chapter Objectives
  • System Description
  • Cat. Nos.
  • DeviceNet Compatibility
• Chapter 2 - Installation
  • Chapter Objectives
  • Storage and Operation
  • Electrostatic Discharge
  • Remove Power
  • Approximate Dimensions
  • Module Installation
  • DIN Rail Mounting
  • Gland Plate Mounting
  • Wiring Diagrams
• Chapter 3 - Operation
  • Chapter Objectives
  • Basic Configuration (Accepting I/O Module Configuration)
  • DeviceNet MAC ID (Node Address) Configuration
  • Autobaud Configuration
  • Choosing the I/O Assembly Data Format
  • Mapping to the Scanner
  • Advanced Topics
    • Registering Unrecognized Devices in RSNetWorx
    • COS Mask Parameters
      • IO Mod COS Mask
      • Net Out COS Mask
    • Input Filtering
    • DeviceNet Explicit Messaging
    • I/O Modules and DeviceNet
      • Configuration of Output Fault and Idle Behavior
    • Mod/Net Status LED
    • I/O Status LED
• Chapter 4 - Programming
  • Chapter Objectives
  • I/O Mapping
    • Verifying the Input Assembly
    • Verifying the Output Assembly
    • Programming Explicit Messages
• Chapter 5 - Specifications
  • 198-DNG, 198-DN (DeviceNet Modules)
  • Mod/Net Status LED
  • I/O Status LED
  • 198-DNP (Mini DIN Pass-Through)
  • 198-IB2S (Sensor Module)
  • 198-IB4 (4-Input DC Module)
  • 198-IB4S Series A (4-Input DC Module DS)
  • 198-IA2 (2-Input AC Module)
  • 198-IA2-G4 Series A (AC Sensor Module)
  • 198-IA1-G4-9000 Series A (9000 Sensor Module)
  • 198-OW2S (2-Relay Output Gland)
  • 198-OW2 Series A (2-Relay Output DIN Module)
  • 198-OW2-G4 Series A (Relay Valve Module)
  • 198-OW2S-Q5 Series A (DeviceNet Valve Module)
  • 198-IA2XOW1 Series A and B (AC Starter Module)
    • Series A to Series B Changes
  • 198-IB2XOB1 Series A and B (DC Starter Module)
    • Series A to Series B Changes
  • 198-IB2XOW1 Series A and B (DC Input Relay Output Module)
    • Series A to Series B Changes
  • 198-IB2XOB5S Series A (Drive Preset Speed Module)
  • 198-IB2XOB2S-Q5 Series A (Drive Preset Speed Module)
  • 198-G1P (Gland Plates)
• Chapter 6 - Troubleshooting
  • Chapter Objectives
  • Diagnostics
  • Red I/O Light
  • Red I/O Light — Noise
  • DeviceNet Connection and Autobaud
  • Low DeviceNet Voltage
  • Excessive Number of Modules
  • Invalid ID
  • Checksum Error
  • Discontinuity Error
  • I/O Module Current Errors
  • Sensor Undervoltage Error
  • Shorted and Open Sensor Detection
• Appendix A - DeviceNet Information
  • Product Identification
    • Product Type
    • Product Code
  • DeviceNet Implementation
  • Operating Modes
    • Power-up Reset Mode
    • Run Mode
    • Error Mode
    • I/O Error Mode
    • I/O Idle Mode
  • DeviceNet Object Definitions
    • Identity Object
    • Message Router
    • DeviceNet Object
  • Assembly Object
    • I/O Modules and “Byte-wise” I/O Assemblies
    • Byte-wise Output (Consumed) Assemblies
      • Instance 102
      • Instance 104
      • Instance 106
      • Instance 110
      • Instance 111
      • Instance 112
    • Byte-wise Input (Produced) Assemblies
      • Instance 103
      • Instance 105
      • Instance 107
    • I/O Modules and “Nibble-wise” I/O Assemblies
    • Nibble-wise Output (Consumed) Assemblies
      • Instance 100
    • Nibble-wise Input (Produced) Assemblies
      • Instance 101
    • Custom Parameter Based “Word-wise” I/O Assemblies
    • “Word-wise” Bit-Packed Assemblies
      • Instance 180
      • Instance 181
      • Instance 182
      • Instance 183
      • Instance 184
      • Instance 185
      • Instance 186
      • Instance 187
      • Instance 188
      • Instance 189
      • Instance 190
    • Assembly Object Services
    • I/O Assembly Instance Summary
  • Connection Object
  • Discrete Input Point Object
  • Discrete Output Point Object
  • Discrete Input Group Object
  • Discrete Output Group Object
  • Acknowledge Handler Object
  • DeviceNet Interface Object
• Appendix B - Motor Starter Operation
  • Setting the Motor Starter Type
  • Motor Starter I/O Assemblies
    • Standard Distributed Starter I/O Assemblies
      • Standard Distributed Starter Output (Consumed) Assemblies
      • Standard Distributed Starter Input (Produced) Assemblies
      • Reversing Distributed Starter I/O Assemblies
      • Reversing Distributed Starter Output (Consumed) Assemblies
      • Reversing Distributed Starter Input (Produced) Assemblies
    • Inverter Type Distributed Starter I/O Assemblies
      • Inverter Type Distributed Starter Output (Consumed) Assemblies
      • Inverter Type Distributed Starter Input (Produced) Assemblies
  • Distributed Starter Specific DeviceNet Objects
    • Control Supervisor Object
    • Overload Object
• Pub. No/Date