SANRAD I3.1.1205 - Manual (Page 136)

7-18 SANRAD V-Switch CLI User Manual
Adding Initiators to an Identity
If you are working in
a V-Switch cluster,
each initiator must be
added on both V-
Switches.
After creating an identity, you can begin adding hosts by their iSCSI
initiator WWUIs to the identity. The identity is a group of iSCSI initiators.
It is not enough for an authorized host to request access to a target. The
host must be requesting access from the correct iSCSI initiator. Use the
CLI command acl identity add name to add iSCSI initiators to an
identity. Repeat this command to add all of the desired host initiators to
the identity.
acl identity add name
You need to define two parameters to add an initiator an identity:
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-id IDENTITY ALIAS OF I DENTITY MANDATORY accounting
-name INITIATOR NAME WWUI OF
INITIATOR MANDATORY iqn.1991-05.
microsoft:
steven.sanrad