SANRAD I3.1.1205 - Manual (Page 99)

Chapter 6: Volume Configuration 6-7
Example:
If you are working in
a V-Switch cluster,
this volume must be
configured on both
V-Switches.
In Figure 6-2, the logical unit, LUN0 on Disk 1, is converted directly to a
virtual transparent volume, Transparent 1. This RAID device has only one
LUN. For each LUN configured on a RAID device, the V-Switch registers
a disk. Therefore, a RAID device with five LUNs will appear to the V-
Switch as five disks.
volume create transparent –vol Trans1 –d Disk1
1
0101
Trasparent
Volume 1
RAID Controller
Disk 1, LUN0
Figure 6-2. Transparent Volume 1
After creating the transparent volume, you can use the CLI command volume
show
to verify the volume creation.
volume show